This is the preferred valve for installations where weight reduction of system structures is required or where spacing problems occur in comparison to other similar type valves.
They are also used to prevent backflow.
Widely used on offshore platforms for the extraction of crude oil, gas and their derivatives.
Used to prevent backflow; usually fitted downstream of a pump.
Lug style valve has holes through which the mounting studs of the companion pipe flanges are driven.
Central shaft is supported by retainers assembled inside the body and fixed by tightening bolts, avoiding leakage to the atmosphere as there are no connections to the outside of the body.
Cast iron refurbishing qualified in accordance with ASME B16.34 radiographic requirements
OVERVIEW
This is the preferred valve for installations where weight reduction of system structures is required or where spacing problems occur in comparison to other similar type valves.
Slug type design in accordance with API-594 Type A.
Lug style body produced by inversion casting process from NPS 2 to NPS 12; NPS 14 and above by hard sand process (no bake process).
Two half discs (dual plate).
NPS 2 - NPS 48 diameters.
Inside in accordance with API-594 published tables.
RF or RTJ ends in accordance with API-594; RF or RTJ flange finishes in accordance with ASME B16.5 from NPS 2 to NPS 24; for NPS 26 valves and ASME B16.47 Series A major flanges.
Flange end spacing in accordance with API-594 table 2.
Fixed seat with weld overlap in the sealing area (overlapping).
Classes 150, 300, 600, 900, 1500 and 2500 #.
Shaft and stop bolt internally body-bound to prevent leakage to atmosphere.
2 internal supports.
Tightening screws.
Inconel X-750 spring; in NPS 8 and larger valves with two springs.
Performance testing in accordance with standard API-598.